BILT HAMBER TOUCH LESS PRE WASH SNOW FOAM 5L

About this product
Bilt Hamber Touch less is a new eco-friendly pressure-washer, pre-clean, snow foam which can be applied by pump spray or trigger. Applied at typically a 4% PIR this bio-degradable sugar-based product provides truly exceptional levels of cleaning of automotive paintwork. Unlike other petrochemical-based cleaners. This snow foam is free-and-easy rinsing, easing the effort of subsequent bucket washes and massively helping post-treatments bond too. Touch less also contains corrosion inhibitors. It comes packed in a 5 litre pH ~12 bottle and contains no phosphates, solvents, NTA, or caustic soda.

Bilt Hamber Touch less is designed to allow for superior and simple application of our new paint protection product Touch on. Touch less can be applied with trigger spray, pump spray, pressure washer, or snow foam lance. The minimum recommended dilution rate should be 2% PIR (Panel Impact Ratio) and maximum up to 5% for very dirty vehicles. One litre of diluted product should last 4-5 washes. Apply to cool panels in shaded conditions. Do not allow this product to dry in use.

How to use
1. Fill the detergent bottle or reservoir (on machine or lance) up to capacity with plain water. Turn detergent feed to full. Take a large bucket or container and discharge the lance into this, watching the detergent bottle until empty. Once empty, stop.

2. The following calculations will achieve 4% dilution; Measure the total amount collected and multiply this number by 0.04 (Total can be measured in either volume with a measuring jug or by weight) this is the amount of TOUCH-LESS to use.

3. Add the calculated amount from STEP TWO to the pressure-washer reservoir and top up to full with cold water and shake in for a few moments.

4. Apply touchless to entire vehicle or panel by panel. Allow to soak for 1-5 minutes (but never allow to dry). Power-wash off.

Specificaties: